Acrylic info.

[Artie]

A friend is looking for a 125 acrylic drilled for a wet/dry system. Needs to be seemless all around. Will be used for a room divider. I would imagine it has to have rounded corners??????? Suggestions for a manufacturer?? Thanks !!!!!

[Afreakin]

Tenacor

http://www.tenecor.com/

Many tanks to choose from. That is the one I gave to Wayne.

[Flareside]

I had a 110 gal Tenecor but was very unhappy with it. The wet dry was on the back. It did function very well, however when I performed weekly water changes, the pumps needed to be turned off when the water level went below 2".

After refilling and upon start up- the pumps were turned back on and this would again start the water flowing over the foam and bioballs and loosening some of the sludge on them- sending lots of gunk and grime into the freshly cleaned tank. Restarting the wet dry system was Very frustrating.

[Artie]

Thanks for the tips boys !!!!!!!!!!!!